This didn't fit not, even close. It was only sitting on 2 corners or like a chair with one leg too short. It took one inch of shims before it sat right. Expect to need a welder, a drill, a drill tap and a grinder to fix which at this point defeats the purpose. The swivel base I bought did fit perfectly on the oem base but one hole was half way out on the Koolands base. I was told I was going to get another one shipped but it never came and lost hope at this point. Kooland is not a thrustworthy company. They will lie to you, not keep their end of the bargain by sending you something defective in every possible way and walk away. This quickly became obvious when I called for help explaining the problem and was told to torque it down. If it needs one inch of shims to sit right, I just can't comprehend the amount of distortion this would induce, clearly dealing with somebody who couldn't care less. The minute I'll be less busy I will go on every van forum and tell everybody who you really are...
This was a nice upgrade to our Sprinter van. Adds another seat to a small area.
These do not fit the ram promaster. The bracket gets in the way of the slide mechanism. This makes the seat no longer slide back and the seat does not sit flush with the spin bracket. Watch the tutorial video, you can see it doesn’t sit flush and others in the comment section have the same issue.
These brackets fit my 2020 Transit with manual seats perfectly. I saw people struggling with other brands but these were fine. The included drivers e-brake lowering bracket was a bit hard to figure out. It does work. Some printed instructions would have been helpful.